Chemglaze H322 (also called Aeroglaze)

A.12.1. Chemglaze H322 (also called Aeroglaze)
PRODUCT
Type			Heat-activated, Electrically-conductive, Matt-black Coating
Chemical Composition			Polyurethane
Manufacturer	Lord Corporation 111 Lord Drive P.O.Box 8012 Cary, NC 27512-8012, USA			Tel: +1 919 468 5979 Fax: 1 919 469 5777 Email: www.lordcorp.com
Europe	Lord Corporation (Europe) Ltd. Barton Dock Rd. Stretford, Manchester M32 0ZH UK			Tel: +44 (0)161 865 8048 Fax:+ 44 (0)161 865 0096 Email: www.lordcorp.com
EXPERIENCE & AVAILABILITY
Development Status			Commercial Product
Cost Range			Low
Lot Reproducibility			Fair
Space Experience			Extensive
GENERAL PROPERTIES (Physical, Mechanical, Thermal, Electrical, Optical)
Nature			Typical Value		Remarks
Solid Content			25%		Manufacturer’s Data
Viscosity			500 cps		Manufacturer’s Data
Electrical Surface Resistance			5 kW £		@ 1V, nonconductive substrate
Solar Absorptance			0.95		ECSS-Q-70-09
Hemisperical Emittance			0.85		ECSS-Q-70-09
Shelf Life			6 Months		20°C
PROPERTIES RELEVANT TO SPACE USE (Effects of and/or on environment)
Nature		Typical Value				Type of Test
Flammability		Pass 21% O₂. (on 1mm thick Aluminium foil).				NASA NHB 8060-1B
Outgassing		TML = 1.6%, RML = 0.9%, CVCM = 0.04%				ECSS-Q-70-02
UV/Particle Effects		Da_s = -0.025				3 Years/OTS spec.
Thermal Cycling		Pass				ECSS-Q-70-04
SPECIAL RECOMMENDATIONS
· Recommended cure: 15 mins. at 125°C after last layer + post cure 50 Hours at 100°C (Specification ECSS-Q-70-34). · Primer: Lesonol 01-66050 may be used for increased adhesion. · This paint (like most others) is not recommended for use in badly vented places where high electrical fields are present in the vicinity (corona risk). · Quality control tests according to ECSS-Q-70-02 are recommended. · Difficult to procure in Europe.

A.12.1. Chemglaze H322 (also called Aeroglaze)