A.17.6. Dunmore DM100
PRODUCT
Type		Aluminised Kapton HN, acrylic (Y966) pressure-sensitive release liner.
Chemical Composition		Polyimide (Kapton HN), Aluminised/Acrylic adhesive.
Manufacturer	Dunmore Corporation Keystone Industial Park, 2900 Wharton Rd. Bristol, PA 19007 USA				Tel: +1 215 781 8895 Fax: +1 215 781 9293 Email: www.dunmore.com
EXPERIENCE & AVAILABILITY
Development Status			Commercial Product
Cost Range			Medium
Lot Reproducibility			Excellent
Space Experience			Good
GENERAL PROPERTIES (Physical, Mechanical, Thermal, Electrical, Optical)
Nature			Typical Value		Remarks
Specific Gravity			1.42		Dupont Data
Thickness			25 mm		Dupont Data
Tensile Strength			170 MPa		Dupont Data
Thermal Expansion Coefficient			20 x 10^-6 °C^-1		Dupont Data(-14°C to 38°C)
Thermal Conductivity			0.0155 W m^-1 °C^-1		Dupont Data (@ 23°C)
Specific Heat			1.09 J g^-1 °C^-1		Dupont Data (@ 23°C)
Volume Resistivity			1.5 x 10^15 W m		Dupont Data (@ 38% RH)
Solar Absorptance			0.15 (aluminised side)		Manufacturer's Data
Normal Emittance			0.60		Typical value only
Shelf Life			12 Months (from manufacture date)		@ Room Temperature
Standard Width			2.54 cm		Manufacturer's Data
PROPERTIES RELEVANT TO SPACE USE
Nature		Typical Value		Type of Test
Temperature Range		-40 to +160°C.		Manufacturer's Data
Outgassing		TML = 0.70% CVCM = 0.04%		3M data / NASA 1061 and ASTM E-595
Moisture Absorption		1.8% @ 50% RH		Dupont Data (@ 23°C)
Adhesion		55.8 g.mm width		Manufacturer's Data / ASTM D3330
Toxicity/Offgassing		Pass		NASA NHB 8060.1A
SPECIAL RECOMMENDATIONS
· All tapes are a standard length of 105 ft ± 5%. (Maximum length available is ca. 160ft.). · All tapes are wound on a 3 ± 0.5 in. diameter core. · Recommended shelf life is a period of one year after date of manufacture, when tape has been stored properly at normal room temperature. · Kapton HN / Y966 acrylic pressure-sensitive tapes can be perforated. · This product is also available with Dunmore's 'corrosion-resistant coating'. · 'Y966' acrylic P/S release liner can also be applied to the metallised surface to provide second-surface mirror capabilities, if desired. · 'Y966' acrylic P/S release liner can also be applied to 51, 76 and 125 mm thick films. · The full Dunmore part number must be designated for precise material description. · 'Y966' high~temperature acrylic tapes are primarily used when high-temperature performance and excellent bond strength are required. · Solar absorptance value is measured on the aluminised side only.